Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinctly SUV feel to it thanks to its larger dimensions. Moreover, the wheel sizes of 19 inches in Ti and ST-L models can be a bit spongy at times. The front tyres of the Qashqai may also lose grip on rough surfaces and its CVT can occasionally display a wrist-flexing torque steering.

It is usually caused by an unresponsive coin battery that can be replaced in just a few minutes. Be sure that the replacement battery has the same size, voltage, and specification.

Water Damage

One of the most common reasons that a Nissan key fob will give the "key ID is incorrect" message is due to water damage. The rubber seals on the key fob protect the chip's electronic components, however prolonged moisture exposure can cause it to malfunction correctly. This is typically the situation when you've dropped your key fob into the ocean or in a swimming pools, but it could be the case if it gets wet due to soapy hands or rain.

If your key fob has been exposed to water over a long period of time then you might need to clean it using isopropyl or electronic cleaner. Alternatively, it might require the attention of a professional for repair or replacement.

If your key fob has to be replaced, it's a relatively simple procedure. Make sure you have the correct multipack (CR2032, 3V). Open the front and rear cases using the flat-head screwdriver. You'll need to remove the clips for retaining metal and pull out the old battery and replace it with the new one. After reassembling the fob, put the mechanical key back in position and ensure that it operates correctly. If not, you'll need to take it to a nissan note key Replacement cost dealer or a professional auto locksmith for the replacement of the chip in the key. Fortunately the chip isn't typically damaged by exposure to water which means that this shouldn't be too expensive.

Dead Coin Battery

The coin battery is another common reason why your Nissan Qashqai remote key fob might not work. These batteries last three to five years, however they may fail over time if the fob has been frequently dropped. You can try replacing the battery with a fresh one, but be sure that it's the same voltage and size as the original. If you choose to use a brand new battery, it may cause the key to be assigned a different key ID. This could prevent it from being linked to your vehicle.

The best method to replace the battery on the nissan key replacement Qashqai key fob is by removing the key fob using the small screwdriver with a flat-head. The screwdriver should be inserted into tiny notch at the bottom of the fob, and turn it around gently to separate the two halves of the key fob. Then, remove the old CR2025 button cell battery and replace it with an alternative one after taking note of its position on the fob.

Before you put the new battery in place ensure that there is no dirt or water damage on the terminals. If there is, clean the terminals with a tiny amount of isopropyl alcohol. Make sure that the pole cables are connected correctly. They should be connected to both the positive and negative poles of your battery.

Fault Diagnosis

If your Nissan Qashqai's keys fob stops working after exposure to clean tap or rain water, this could be a sign there is an issue with the internal chip. You'll require a new keyfob if you can't resolve the issue by changing the battery. If the key fob didn't work after dropping it, it's likely that the chip inside was damaged. It is possible to get the key fob back to work again if you remove and clean the chip using alcohol and paper towels and then insert it back into.

One common error you will see on your car's dashboard is "Key ID Incorrect." This means that the vehicle cannot recognize the key fob, and will not allow it to start the engine. This problem could be caused in numerous ways, including water damage, malfunctions that are not detectable within the key fob circuitry or RFID interference.

The key fob will stop working if the 12 volt batteries are not working or provide enough electrical current. This will affect the remote keyless system and central locking on your Nissan Qashqai, as well as making it impossible to start the engine with the key fob (if equipped with Intelligent Key). Check the batteries in the key fob if you are in a position to lock or unlock your door manually. Try reinstalling the battery to reset your transmitter.

Reprogramming

If the key fob is not been submerged in salt water the device should be able to come back to life after a quick wash with clean water. You can also clean the electronic chip with isopropyl or electronic cleaner. If none of these works It could be the time to replace the entire key fob with a brand new one.

If your Nissan Intelligent Key is still not functioning, there may be a problem with the connection between it and your car. To reconnect it, start by turning the key in the ignition, without turning on the car. Continue this process until you see the warning lights flash twice. After that, turn the car off and take out the keys.

Then, you need to open the fob compartment of your vehicle. It's usually located on the door jamb or driver's door handle. Find the small "program" button and press it. Once the process has been completed, you should hear an audible sound.

It's time to put your Intelligent Key to the test. Stand some distance away from the vehicle, and press all the buttons on the key. If the lights flash or the horn sounds, the key is connected to the Nissan. You can also test it close to the Nissan.