How to Replace a Kia Sportage Replacement Key

The key in many Kia models has a keyless entry system built into. This key typically resembles the remote control and is able to be replaced by a new one purchased from a Kia dealer or a locksmith.

Key fobs may stop working due to various reasons, such as the battery of the coin is dead worn buttons water damage, signal interference and a malfunctioning receiver module. Here are some suggestions to help you get your Kia sportage replacement key working again.

how to unlock a kia optima without keys to replace the remote key or smart key?

Whether your Kia is equipped with an intelligent key, remote key, push to start key, or a standard non-transponder key made of metal, the battery in these keys will eventually require replacement. This is especially relevant if your car displays a message that the remote or smart key is not powered by the battery.

Luckily, it's quite simple to do. To replace the battery on the keyfob, remove your mechanical key from the slit at the back of the fob. Then, you need to pry the cover off. A small screw is inside the key fob to hold the battery in place. By using a small screwdriver take the screw off and pull out the old battery. Insert the new battery and close the slit on the key fob.

Once the key fob has new batteries Test it by pressing the lock and unlock buttons. You're good to go when the doors lock or unlock as expected. You can now utilize your Kia's hands-free lock/unlock feature when your fingers start to get cold or you need to run some errands in Brandon.

Note: Some key fobs (transponder chip or smart keys) might require their programming completed. This requires a particular programming machine that only the dealer or locksmith has access to. Other keys (non transponder keys made of metal), do not need programming. If your key needs to be programmed again, you must know the key code number stamped on the key code tag and then record it in a secure location.

How do you replace a battery?

If the Kia key fob does not respond when you press the lock/unlock button, it is most likely that the battery is depleted. A battery that is not functioning properly can cause other issues, like the check engine light coming on or the engine not cranking correctly. Fortunately replacing the battery on the key fob is a fairly simple DIY project that requires only some basic tools.

Make sure you turn off your vehicle and close all doors prior to starting. Find the small, metal or plastic piece that is on the bottom of your key fob and play with it until a metallic key is released. This key can be placed inside the driver door handle to unlock your car.

To replace the battery in the key fob, you must remove the cover that covers the rear. Use a pry tool to loosen the latch that holds the black negative cable. Remove the old battery and orient the new one in a way that the "+" positive side faces your face and the "negative" negative side is facing towards the fob's electrical contacts made of metal. Push the new CR2032 battery straight into position, avoiding excessive force to avoid damaging or bending the contacts on the metal.

After you have installed the new battery and turning the key fob on and off in the ignition until the door locks up. You can then test the Kia's Key fob again to make sure it's working as intended.

How to replace a smart key

Depending on the model of the Kia Sportage, you may have a standard key fob or a smart key. The smart key has an embedded mechanical key blade while the standard key fob does not. Both key fobs have batteries that eventually require replacement. Luckily, this is an easy process that takes only two minutes.

Be sure to switch off your Kia, and be on a flat and well-lit surface prior to you begin. Be aware that the fob can contain small pieces that could be thrown off should you not be careful.

The small release button is located on the lower backside. It could be a circular button or a rectangular slot. When you press it mechanical key blade, it will come out and you can then open the key fob.

Once the key fob is open, remove the old battery. The new battery is CR-2032, and can be bought from a local or online auto parts shop. After installation you should be able to lock and unlock your car with your key fob - even if the engine isn't running!

How do I replace the mechanical key

The Kia key fob is an amazing feature that lets us lock and unlock our vehicle with the press of an button. As with all devices it is possible that the Kia key fob can You reprogram a kia key fob occasionally have problems. There are ways to address these issues and keep your key fobs in good working order for a long time.

A dead or low-quality battery is one of the most frequent problems. This can cause your device to stop working or operate intermittently. If this is what you are experiencing it is time to replace the battery an entirely new battery.

If this does not resolve the issue, try using a flathead screwdriver standard to wedge the fob's plastic casing open. Be sure not to damage any internal components or scratch the plastic. Once the battery is removed and replaced with a new one.

Once the new battery is in, close and open the doors with the mechanical key (every Kia fob comes with an emergency mechanical key that can fit in the slot). Test the key fob to make sure it is working properly. Contact a dealer, or a locksmith to address the issue in the event that the key fob is not working. Make sure they cut you an emergency key that can work for all trunk and door cylinders to avoid lockouts again.